Why won’t my paddle board inflate?
The lack of pressure buildup is caused by a lack of lubricant in the pump or unevenly distributed lubricant. If the pump won’t build pressure all you need to do is add some sort of lubricant, like Vaseline. Unscrew the top of the pump and add a glob of lubricant to the cylindrical piece on the inside. The gauge on your inflatable board will not register until the board is at 7-8 PSI. Even though it seems rigid, it will still be able to get more pressure. There is no way to over-inflate or damage the board with the pump provided. Just keep pumping until it registers!Before you start inflating, be sure that the valve’s yellow pin is in the upright position. This means the valve is closed and will prevent all of the air from rushing out when you are finished pumping.
What PSI should I pump my paddle board up to?
Generally speaking, we’d suggest aiming for 15-22 PSI. This should ensure that your board reaches the levels of stiffness required for optimum stability, without you having to exert too much effort inflating your board or battle resistance from the valve when deflating it. The time required to inflate an inflatable paddle board varies based on the pump type, experience, and target PSI. Manual Hand Pump: Approximately 4-7 minutes for most users. Electric SUP Pump: Around 7 minutes or less, offering a hands-free experience.For short term storage, leaving your board inflated is absolutely fine, permitting it’s in the perfect storage spot as we outlined above. All inflatable paddle boards will lose air pressure over time when left inflated, but it’s also key to remember that air pressure expands in extreme heat.With proper care and maintenance, a well-built inflatable paddle board can last anywhere from 5 to 10 years or more. However, it’s essential to keep in mind that the lifespan of your iSUP may vary depending on how often you use it, the conditions in which it’s used and stored, and the quality of construction.Your paddle board is fully inflated when it feels firm to the touch and does not flex under pressure. Most boards have a recommended PSI, typically around 12-15 PSI, which you can check using the gauge on your pump.
How many pumps to inflate a paddle board?
Inflate paddle board and you will begin to visibly see the board inflating. The last 30-40 pumps will be fairly difficult. When you think the board is fully inflated, take a minute break and then give it 10-20 more pumps. Smaller women or children may require help to inflate the board. Over inflation: The Leading Cause Overinflation is the most direct path to a paddle board bursting. Boards are designed to operate safely within a specific range of air pressures, measured in PSI (pounds per square inch). Exceeding this limit can strain the board’s materials and seams, potentially leading to a burst.
What PSI should a hydro force paddle board be?
Use a manual or electric pump to inflate the board to the recommended pressure (typically 12–15 PSI). Check the pressure gauge to avoid over-inflating. Generally speaking, we’d suggest aiming for 15-22 PSI. This should ensure that your board reaches the levels of stiffness required for optimum stability, without you having to exert too much effort inflating your board or battle resistance from the valve when deflating it.The best inflatable stand-up paddle board PSI level is anywhere from 10 to 15. Most people inflate their board to about 10 to 12 PSI. A higher PSI will help if you are riding in cold or choppy water. If you need a bit more stability, try increasing the PSI of your board as well.
How do I pump up my paddle board and not let air out when I take off the pump?
Turn the SUP board valve stem to the CLOSED (UP) position. If you leave the valve stem in the open position, you will lose all of the air pressure when you remove the hose. If you leave the valve stem in the open position, you will lose all of the air pressure when you remove the hose.