What is the bottom board on a house called?
What it is: the fascia is a long horizontal board or band placed below the lower edge of the roof’s overhang. It’s fixed to the roof trusses’ lower ends and supports gutters. Fascia or fascia board is installed at the edge of your roof, just under the roofline. It’s usually a flat piece of trim, wider than the trim used on the rest of the home, but normally made of the same material. Occasionally, it may be decorative in style, but normally fascia is fairly subtle in presentation.The main role of a fascia board is to stabilize the rafter ends and anchor the gutters while also providing a decorative covering. Fascia also gives the roofline a finished look. Without it, the look of a roofline would be unfinished with exposed rafter tails.Rake boards only run diagonally on the gables of a home whereas fascia only runs horizontally along the roof rafters, trusses and gutters. Fascia also protects the entire roof and siding from inclement weather while a rake board only protects the top edges of the siding and brick.
What do you call the boards on the outside of a house?
Horizontal Siding or Lap Siding Horizontal siding, also known as lap siding or clapboard siding, is a classic choice that suits many architectural styles. This type of siding involves long, horizontal boards that overlap each other, providing excellent weather protection and a timeless look. Siding is a type of exterior wall covering that is made of horizontal boards or panels.
What are the boards on the outside of a house called?
Siding. Siding refers to the layer of material placed on the outside or exposed area of a house. Siding comes in a variety of materials, including vinyl, wood, stone, brick, metal, aluminum, and synthetic options. House Wraps Under Vinyl Siding. House wrap is a breathable, paper-like material that covers the entire exterior of a home, sitting between the sheathing and vinyl siding. Its primary job is to block wind and moisture from seeping into the walls while still allowing trapped humidity to escape.
What is a gable board?
A bargeboard or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof. A rake board is a triangular structure seen on gable roofs. It’s a trim board that slopes downwards and runs along the edge of the roof. It’s also called a verge board and the edge is called a rake. The rake is where the roof’s slope meets the end wall.
What is a soffit board on a house?
The soffit definition, on a roofing system, is that the soffit serves a dual purpose – to protect the rafters, the roof’s support beams, from the elements, and to change the look of your roof. If a soffit is not in place, then over time the rafters would rot; and could allow mould into your house. Wind-blown rain can enter attics through soffit vents during storms. Typical soffits have a fascia that is level with the bottom of the vent panel and vent perforations that face downward allowing rain water dripping down the fascia to be blown or drawn into the vent openings.
What is a bargeboard on a house?
Bargeboard. This is the board that is used on the gable end of a house. The condition of the bargeboard can often make or break the look of a house, and over the years it has evolved into some very attractive shapes. Backerboard: A flat material used on the face of the house, between the studs and the siding, to provide a nailable surface for the siding.So, what is “board and batten? It’s a type of siding where thin strips of wood molding—or “battens”—are placed over the seams of panel boards. The result is an aesthetic that is both rustic and chic, with the strong vertical lines providing shadows and textures to the home exterior.